cnc router manual for repairing.

this is cnc engraver cutter machine manual for repairing different problem when machine working!

◆ cnc engraver cutter router when walking or Homing in the opposite direction ?
1 change in Notepad document ; 2 wiring methods to modify the inverter ; 3 modify the motor direction ncstuido software.

◆ cnc engraver cutter router machine does not return to normal mechanical origin ?
1 in the opposite direction ; 2 controller card failure or loose ; 3 limit switches or data line failure ; 4 drive failure ; . Nearly five-step motor failure .

◆ cnc engraver cutter router spindle automatic stop switch or not ?
1 controller card failure ; 2 drive failures.

When ◆ cnc engraver cutter router open Weihong software, computer Tip "Operation failed" ?
1 Check the board driver has not installed , or the board for a PCI slot ; 2 to reinstall the two data cables , check there is no breakage phenomenon ; 3 boards have problems, replace board .

When ◆ cnc engraver cutter router open software prompts : triaxial alarm, initialization errors IV ?
1 Check the computer and the machine two data lines are not connected well ; . 2 Check the control box adapter plate fuse is burned , replace the fuse ; . 3 Check 85V power supply is normal .

Dislocation occurs or the wrong size when ◆ cnc engraver cutter router engraving ?
1 Check the correctness of the path engraving software ; . 2 Check the screw fastening screw and rod gap size has no loose ; 3 Check the software parameters set correctly .

◆ cnc engraver cutter router X axis Z axis is not certain when walking carrying knives , according to go up but go down ?
1 Check the Z -axis stepper motor is running, the current size of the power and drive or own fault ; . 2 Check the Z -axis stepper motor cable is bad or intermittent cases ; 3 controller card failure.

◆ cnc engraver cutter router spindle motor does not turn or reverse ?
1 Set check inverter parameters ; 2 drive signal cable is reversed .

◆ cnc engraver cutter router open software boot , appears shaft off?
1 drive problems or computer output signal line is bad ; 2 motor line is bad .

◆ cnc engraving engraver cutter router limit phenomenon occurred during the ?
1 Check the sculpture carving a path exceeds the range ; 2 soft limit parameter settings in the software .

◆ cnc engraver cutter router software does not open properly send something carved deformity . ?
1 to re- install the new systems and software ; . 2 Check X, Y -axis screw and the screw is loose ; 3 chisel with a problem.

◆ cnc engraver cutter router spindle motor during operation or turn suddenly stops slower ?
1 Operating voltage instability or overload , you can add a regulator ; . 2 Check the middle line is connected, whether there are sealing off the thread .

◆ cnc engraver cutter router forwards sometimes when setting the origin , the offset distance to the right variable ?
1 limit switch failure, the system returns to the origin of the system in the process of the limit switch is closed and bounce , you can change the limit switch ; 2 drive cable is loose , try to tighten it fixed .

◆ cnc engraver cutter router startup time can be reset to the X-axis , Y -axis , Z -axis position of uncertainty ?
1 limit switch bad ( limit switch is always closed ) , for the can ; 2 bad drive line (X-axis 14 -pin and 15-pin short circuit , Y -axis 13 -pin and 15-pin short circuit , Z -axis 31 -pin and 15-pin short circuit ) , for driving the shorted wire or punishment can be opened ; 3 driver board bad , for the driver board can be.