how to install DX5 head
how to install DX5 head.
How to Setup DX5 Head to The Large format Printer.
1. install the piezoelectric DX5 head , first make sure the machine is normal movement , the machine is connected to the ground very well , the car plate voltage is normal , the nozzle supply voltage is normal ! The easiest way is to use a multimeter to measure whether there is static, car plate voltage , supply voltage and the nozzle on the machine , the Five general Epson nozzle supply voltage 42V DC !
2. aspects of software testing machine movement is normal, a normal reading grating , the light is normal ! Installation Before installing the hands of those who want to be hands touch the conductive body discharges , the operator's hands can not have sweat or moisture , because the nozzle touch the cord is plugged sprinkler nozzle is likely to cause a short circuit ! Also remember not to wear plastic sheeting class easily from static clothing, preferably with both hands under the conditions permit electrostatic ring . When installed must first turn off the power and unplug the power cord to be !
3. nozzle are generally less than two sprinklers data plug wire , wire thread insert checks whether the tilt of the pin , is flat , it is best to use the new plug wire , cable with plug inserted in the nozzle, do not plug firmly any tilt. Scale sprinkler head is generally of both sides of the line , contact with the circuit side , the other side does not touch the circuit , not the direction of error , be sure to check back a few times plugged in , make sure there is no problem in the rack sprinklers installed in the car .
4. nozzle cable car plates : first the machine without turning off the power in case of power to operate ! Not error position , corresponding to the position of the nozzle out of the line must be clear before you start , there is hesitation or doubt do not try to put something first , be sure to consult the manufacturer or ask the right plug wire location pictures, or demolition In addition to changing photographed before each line are marked with tag ! Prevent the plug when not start ! Because the consequences will be very serious , the possibility of errors once burned head very high, because the function of the nozzle line is not the same, is the inevitable burn inserted the wrong head ! There is not inserted in the direction of the head of the anti- fall , once inserted backwards despite that there might not burn the head , but also a probability . After plugging the line must be more checks.
5. all three to five times to check installed, confirm without any problems after opening power , it is best not to open the nozzle first , first with ink pump ink lead over, and then open the nozzle power, if the machine on a power switch
Except , first check whether the normal flash spray , spray normal flash proved successful installation . Flash is not normal spray immediately turn off the power to check whether there are problems elsewhere , which is recognized in the state under the new jets.
6. install sprinklers must be careful, pre-installation work a little less, and the job to be coherent .
7. sprinklers installed before checking whether the new nozzle is also very critical.
8. insert ink sac when the data do not allow the ink to drip line, because the ink will go down the data stream directly into the circuit , into the circuit may cause a short circuit burned directly head.
9.piezoelectric DX5 head about a year and a half normal life around . Choose high -quality ink , while more attention to the maintenance of machines and sprinklers , can prolong the life of the nozzle.
