Piezo DX5 DX7 head maintaining.

Follows info to let you know how to protect you Piezo DX5 DX7 head.

if DX5 DX7 head nozzles to clean the nozzles , need distilled water , lint-free cloth and wipe a plate .

1, with a cloth soaked in distilled water .
Net absorption gently with a damp cloth ( do not rub ) nozzle nozzle at the bottom of 3-5 times.
Repeat this process for all nozzles to be cleaned . Each nozzle should use a clean area of the cloth, to avoid color mixing nozzle . Test to see if the nozzle is clogged nozzles . ( See Printing and explain the initial samples and color test operation for more information. )
If the blockage persists , you can put a little distilled water and put a small amount in the heating plate. ( The nozzle on a platter , because water can leak into the back of the chip , so the water should not be higher than the bottom of the 2CM.)
The nozzle upright in warm water . Wait 30 seconds , then dry nozzle test .
Each nozzle should be cleaned with water . In addition, an ultrasonic cleaner can also be used to clean the nozzle .
To clean microarrays requires alcohol and a cotton swab or lint-free cloth to scrub .
Turn off the photo machine power .
Clean cloth or cotton soaked in the wine .
Gently scrub the nozzle back microarrays , attached to dirt or ink.
Repeat this for each nozzle process to ensure a clean portion of each nozzle is clean with a cloth or cotton swab to scrub . Small frame out of the nozzle with a clean wet or wet cotton swab to gently scrub the shelves of contact with the car . After cleaning , fitted with sprinklers, make sure they are seated correctly. Photo machine cartridges leak -
After completion of pumping ink , do not unplug the syringe immediately , wait 20 seconds before they can be pulled out to be pressure-balanced to prevent air from entering .
if you do not have DX5 DX7 head printer.