Laser engraving machine component installation.

Laser engraving machine installation requirements for each component.

1. The direction of shaft equipment. Requirements:
(1) rotatable drive shaft
(2) synchronous wheel fastening two.
(3) To make the whole shaft and wheel formation, with attention to the inner diameter of the bearing and the shaft, bearings and bearings with outside diameter not allow loose and beat, the sound of friction resistance

2 light pipe cover and the back cover of the equipment. Requirements:
(1) on the fastening screws are full, no omissions
(2) the appearance of smooth, spray surface without scratching three.

3 about equipment rail. Requirements:
(1) Note that the parallelism.
(2) To smooth glide beam pat did and did not beat resistance and friction sound.

4. Beam assembly equipment. Requirements:
(A) no friction between the dust cover and the guide rail
(2) slidably car
(3) moderately elastic belt, no distortion, no wound and trachea
(4) about the vertical beam bearings and guide wheel no cracks, turning flexible and fastened to the cradle
(5) The towline to run freely, ventilation smoothly
(6) X to the tensioner without tilting, rotating flexible no significant beating, the extent appropriate tensioning
(7) the motor shaft without bending, no conical pendulum
Fine (8) the inner part of the beam pipe and straight, with no belt wrapped around the tube length suitable tank part, to ensure the operation does not pull the beam loss

5 belt equipment. Requirements:
(1) an appropriate degree, without distortion
(2) belt buckle tight, smooth appearance six.

6 Water protection components and equipment. Requirements;
(1) raw material winding in the right direction, winding parts do not go beyond the end face of pipe fittings
(2) the amount of suitable raw material winding without leaking.