New laser engraver cutter installation manual.

due to many laser engraving machine brands, different brands have different installation methods, if the following installation methods are not suitable for your laser engraving machine, we recommend that you consult your supplier, installation and commissioning under the guidance of technicians.

Now we are talking about our brand laser engraver cutter machine installation manual.

Firstly:
after receiving the machine, first check the box whether anythere is damage, we should first check whether the laser tube is damaged, then check whether the whole appearance of scratches and accessories are complete.

Secondly:
laser engraving machine should be placed in ventilated, dry place, away from the ground wire should be close. After commissioning a good machine and then try not to move the machine, or to re-adjust the optical path.

Finally,
laser engraving machine installation and commissioning.
Installation:
1. the installation ground: engraving machine to install a standard ground.

2. install the fan: The fan is mounted to the back of the slot machine, and then connect the exhaust pipe.

3. installation of pumps: pump to the back of the engraving machine (with ties) of a pipe. Then put the pump into a bucket containing pure water, the pump power plug 220V power supply, ensure that the water cycle (when the laser engraving machine is powered test, make sure the water cycle).

4.  data cable: Connect the laser engraving machine and computer data lines. (Note that the data cable to connect the computer to the state authorities and engraving machines under)

5 dongle: the use of the software is encrypted to prevent outsiders malicious actions, no dongle, the software will not run, put the dongle plugged into the computer's USB interface software can work.

6, install the software: the CD into your computer, install the engraving machine software dongle serial number to see the disc.
Debugging:
1, start the test: laser engraving machine turned on, the car will automatically detect, return to the upper right corner.
2, the current adjustment: press the "test current" button held down, and adjust the "current regulation" button, so that the current is in the right position, release the "test switch" button, so that the operating current of the machine will regulate , under normal circumstances, the work is more appropriate in the current 6-10 mA, depending on the carving material, can be suitably adjusted current size, the greater the current, the stronger the laser, scored about deep.

3, positioning: the engraving material on the fixture, the upper flat surface of the material and plywood sculpture is in a horizontal line, in order to achieve the best results sculpture, you can put a wet paper in the material above, it covered materials to avoid burning materials because the current is too large, then use engraving software publishing. Software Point "sculpture Output", then enter "abscissa: 100; vertical coordinates: 20," point "position preview" position according to specific criteria for each computer, make their own adjustments. Note: "Engraving speed: 5," "Interval: 2."