Purchasing laser cutting engraver machine Precautions.

Purchasing laser cutting engraver machine.

With the increasingly fierce market competition and the rising market demand for quality, such as metal laser cutting machine laser equipment gained wide use.

How to choose a suitable CO2 laser cutting machine? Here, the author analyzed solve this problem, I believe that the choice of a suitable metal laser cutting machine is generally dependent on the production of the material, in general, need to consider the following questions:

1, cutting sewing fine: laser cut slotted typically 0.10mm-0.20mm;
2, the cutting surface is smooth: laser cutting burr-free cutting surfaces law;
3, the thermal deformation: laser processing laser slotting thin, fast, energy concentration, so spread the heat on the material being cut is small, causing deformation of the material is very small;
4, suitable for processing large products: mold manufacturing large products of high cost, laser processing without any mold manufacturing, machining and laser punching completely avoid the collapse of the material forming the side, you can greatly reduce production costs improve product quality;
5, very suitable for development of new products, shorten the development cycle: Once the product drawings forming, laser processing can be carried out immediately, you can get kind of new products in the shortest possible time;
6, save material: laser processing using a computer program, you can put different shapes hedge cutting materials to maximize material utilization.

Co2 Laser engraver cutting machine 13 points for operate:

1, laser cutting machines comply with the general safety rules, we need to start the program in strict accordance with lasers, laser cutting machine operation starts.
2, the operator must be trained and familiar with the equipment structure, performance, control operating system knowledge.
3, good labor required to wear protective equipment, in the vicinity of the laser beam must wear protective glasses compliance.
4, did not clarify whether the material can be used before a laser irradiation or heating, not its processing, in order to avoid potentially dangerous fumes and vapors.
5, when the device is switched operators are not allowed to leave their posts or trustee to be managed, as indeed should be shut down or need to leave off the power switch.
6, to put a fire extinguisher readily available and where; want to turn off the laser or the shutter when not working; Do not place paper, cloth, or other combustible materials in the vicinity of the laser beam is unprotected.
7, in the process when abnormal, should be immediately shut down, timely troubleshooting or reporting officer.
8, keeping the laser cutting machine, bed and surrounding grounds clean and orderly, no oil, parts, lumber, scrap pile as required.
When 9, when using gas cylinders, welding wire should avoid crushing avoid leakage accident occurred, the use of gas cylinders, gas cylinders shall comply with the monitoring of transport regulations prohibit cylinders prolonged sun exposure in the sun or near a heat source, open the cylinder valve operation must stand on the side of the lip.
10, when repairs to comply with the high-pressure safety procedures, according to the rules and procedures.
11, should be manually low X, Y direction start after boot the machine, check to make sure whether the abnormal situation.
12, after the entry of a new part program, you should first test run, and check its operation.
13, when the device is working, we have to observe the operation of the machine, in order to avoid laser cutting machine out of the valid travel range or two collided causing the accident.