Hot laminating machine user manual.
Hot Laminating machine Troubleshooting user manual.
1. Motor rotation, but not heated.Usually relay failure, by measuring the voltage across RL can determine whether the 220V. If no voltage or voltage is too low, indicating that the relay does not pull or pull poor, mostly for relay contacts K damaged or ablation, replace or remove the sand light relay contacts.
2. Not heated.
Since the thermistor is in contact with the surface of the finale, with the finale of the rotating friction, over time will fall off, loose or damaged, should be re-fixed back in place and make good contact with the finale of the surface. If damaged, replace the thermistor.
3. Big noise.
Due to long-term high temperature machine, the drive gear lubricant easily dried, resulting in large noise. After re-oiling, you can troubleshoot.
Laminator Use
(1) the power: plug in the power cord, the switches are placed in the "clockwise" "seal plastic" position, turn on the power switch.
(2) set and adjust the temperature: adjust the "thermostat" knob, then the temperature gauge pointer is set at about 150 ℃, warm-up to the "warm-up" indicator light to start molding.
(3) the plastic method: plastic photo documents to be sandwiched between two sheets of film based cards, fed from the front, between the export documents from their own boards, and pulled out, plastic is completed.
(4) shutdown.
How to choose good hot laminator.
1. Clear time
Laminator before you buy you need to know that you need every day or every hour how many plastic items, plastic laminator different speed is not the same, but not the same warm-up time. Therefore, according to their own needs to choose their own laminator.
2. The maximum wind speed width
Laminator when you buy according to their needs size plastic items to buy. For example: You just need plastic ID cards, driver's license and other documents, then the A6 laminator can meet your needs. If you want a larger plastic items, such as A3 paper size construction drawings, then you need to buy an A3 Laminator's.
3. The maximum thickness of plastic
Different maximum thickness of different plastic laminator, and now the plastic thickness laminator is generally about 1.5mm. Users according to their own needs to choose the right machine.
