Mini Laser seals stamps engraving machine Manual.

do you know how to working with Mini laser seals stamps engraving machine? Now we are tell you how to good operate this machine if you have it in your hand.

Laser seals stamps Engraving machine is integrated into the latest optical, electrical integration technology and the design of high-tech products, through the power supply to the laser, the reflected laser light emitted by the laser focusing lens and then carving through the lens needs carving material above. CNC engraving machine is one of them, it is simple to operate, the font specification, easy to learn to use, orthography, against the word, the word free conversion of yin and yang. Here we give in terms of installation method under CNC engraving machine. 

1, the operation panel description: 

Power switch: used to start or shut down your computer engraving machine. 

Current indication: CNC engraving machine is used to indicate the current size. 

Current regulation: With this potentiometer to adjust instruction based on current carving current size. 

Lighting switch: to enable or disable engraving machine inside lights (certain machines no such switch). 

Laser switch: used to control whether the laser light, when the switch is turned on seal engraving state (ie press). 

Test Switch: When this switch is pressed lasers emitting at this time the current size of the potentiometer is used to adjust the time according to the meter sculpture display data adjustment. This switch is only used to debug the machine and check the current size of the sculpture when, you need to disconnect the machine when working properly, the computer will automatically control for carving. 

2, the print line: 

parallel connected to the computer (two rows of needle-shaped), and the other end connected to the output of CNC engraving machine interface (front right side of the machine). 

Pump: The pump outlet connected to the aqueduct CNC engraving machine (long pipe), and then put into the water pump (suction pump at work, short catheter water, forming a loop cycle), in front of the machine working the pump power plug , the water in the circulation state, to reduce the temperature of the laser tube. 

3, the exhaust system: 

plug in the fan vent engraving machine at the other end on the outside, so that exhaust fumes. 

4, software CD: 

Laser seals stamps engraving machine for installation typesetting software. A second type is installed inside the upper right corner of Branch Pa positioning software three type IV: (II Edition) installed inside the upper left corner of A positioning software / (four plate) Installation Division Pa License v7.9 software, no encryption lock the Five motherboard USB port installed special software 

5 dongle:

the use of the software is encrypted to prevent outsiders malicious actions, no dongle, the software will not run, put the device plugged into the computer's USB interface software can work. 

6, manual: including engraving machine engraving machine installation instructions and software installation instructions in two parts.