Cnc router Artcut software manual study
Cnc router Artcut software manual study.
Artcut is one of cnc router design software, it is very useful for all cnc engraving cutting machine. follows we are talking about the Artcut design steps.
Cnc router machine is mainly used for badges, the licensing department of the color plate engraving, acrylic, PVC cutting and acrylic, PVC three-dimensional sculpture, plastic mold, architectural models, organic by mold, sculpture and other arts and crafts.
A: Processing Methods
1, badges, licensing department carving common methods are "2D, the original line output."
2, acrylic, PVC, Teflon board, MDF cutting methods have "cut."
3, organic, PVC three-dimensional carving methods are: "3D".
B, badge production:
Involving tools
Arrow - Select mode (select and move objects)
Graphics - drawing rectangle tool
Changing the size of the graphic pattern --____
English alphabet - Typing
Change the font
Right attributes: change spacing, italic.
Alignment Tool: SHIFT plus the election, after the chosen benchmark.
c, a single production process
① define the rectangle (specified size: After drawing the rectangle, the size of the dot pattern graphics editor to modify the required size).
② moving rectangle carved into the bottom left corner of this page may be
③ Enter the text (point T, enter text mode, change the font, word spacing).
④ typesetting (point arrow)
Back to select mode, use the alignment tool).
⑤ enter - hit 2D, select the word or icon in the dialog box that appears select incised, carved depth (color plate engraving of 0.05-0.1), tool compensation hook, carving the way (horizontal milling bottom), overlapping rate (30- 40), the magazine selected flat knife (size depends on the minimum width of the machining tool graphic strokes, can try to do with a large tool knife), tool set (half the width of the whole angle of tool parameters W1, angle a, the width of the tip width W2 increase knives), secondary processing methods Crochet overlap rate fixed knives and carving knives manner consistent (if carved out in some places, the election a knife). Select the frame, click on the cut, tool selection (to be straight edge knife with a straight handle, with cone bevel knife), engraving depth (color plates cut into 1.4mm, retain cusp), save path (standard G code, carrying the knife away 2MM, kept the name)
D. production process more
① copy the contents of the same (using bulk copy)
Good single badge design, the overall selected, point straight copy tool, set level, the number and spacing directions click OK. Interval is set between the breastplate (typically 1.5mm), will use the same engraving method and a knife with the same text, an icon combination, a combination of frame, and making a single badge similar.
E, Caution
Tool selection should replace descending
Example: When the number of badge more, if only a small knife with a 0.3 stroke carved out.
Solution: 1) change 0.2 or 0.1 of the knife (depending on the font to be)
F. will be carved out of the stroke width to enlarge
b, the knife depth: 2D, drawing 0mm, two-dimensional cut 1 .4 mm.
c,
Carving way:
(1) 2D engraving:
(2) 2D: Carving manner "horizontal milling bottom", secondary processing methods with Crochet, "Tool compensation" "Keep sharp" tick.
(3) the original line output: the tool along the center line of the file passes.
(4) Crochet: from the outside to the inside of the ring side pocket can limit the number of engraving
4, the parameter settings:
Spindle speed (15000-20000)
② engraving speed (1000-2500) (speed graphics processing speed depends on the size of the stroke)
③ movement speed (1500-3000) (speed graphics processing speed depends on the spacing between strokes)
